Dryer drum support roller. The rollers tend to wear at the same rate so both should be replaced while the dryer is apart.

OEM Part - Manufacturer #WP37001042

Dryer drum glide pad. Drum glides help to support the front of the dryer drum as it rotates. If the drum glides are worn out, the dryer will be noisy. Because the glides wear out at the same time, you should replace all of the glides together.

OEM Part - Manufacturer #WP37001298

Idler pulley wheel and bearing assembly. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

OEM Part - Manufacturer #WPY54414

Dryer felt pad for drum glide. Fits under drum glide, peel and stick

OEM Part - Manufacturer #D510189

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

OEM Part - Manufacturer #W10169313

Dryer drum drive motor assembly with pulley. The pulley is not available separately from the motor assembly. If the dryer does not run look for a defective door switch or start switch before replacing the motor. If the motor hums or buzzes and cannot be turned by hand then it is likely defective.

OEM Part - Manufacturer #WP2200376

Dryer door strike

OEM Part - Manufacturer #D510181

Door catch kit, includes catch and clip (metal) Replace both parts for best results

OEM Part - Manufacturer #LA-1003

Drum support roller axle. *Roller will be TIGHT on new shaft. Gently tap roller onto new shaft with a hammer.

OEM Part - Manufacturer #WP40113601

Roller will be TIGHT on new shaft. Gently tap roller onto shaft with a hammer.

Washer. Has a 3/4-inch outside diameter.

OEM Part - Manufacturer #WP233520

Retainer snap ring. Used to hold drum rollers and idler pulleys in place.

OEM Part - Manufacturer #WP23748

Front cover top retaining spring clip

OEM Part - Manufacturer #WP22001650

Cycling thermostat, 3 terminal L153-15F

OEM Part - Manufacturer #WP503979